Study About Electronic Fuel injection systems, its advantages over Mechanical Fuel Injection System : A Review

Authors

  • Himanshu Shukla B.E., Department of Mechanical Engineering, Acropolis Technical Campus, Indore
  • Shubham Shukla B.E., Department of Mechanical Engineering, Acropolis Technical Campus, Indore

Keywords:

Fuel injection, Electronic Fuel, Injection system, Carburetor, Conventional

Abstract

Fuel injection is the introduction of fuel in an internal combustion engine, most commonly automotive engines, by the means of an injector. Electronic Fuel injection works on the some very basic principal. The following discussion broadly outlines how or Conventional Electronic Fuel Injection (EFI) system operates. Fuel injection is a Fuel system for admitting fuel into an internal combustion engine. In olden days carburetors are used to fulfils this action. A Carburetor is a device that blends air and fuel for an Internal Combustion Engine. Carburetor works on the Bernoulli’s Principle. The lower its static pressure, and the higher its dynamic pressure the throttle (accelerator) linkage does not directly control the flow of liquid fuel.

References

Murthy, P.V.K., Narasimha Kumar, S., MuraliKrishna, M.V.S., Seshagiri Rao, V.V.R. and .Reddy, D.N.,(2010). Aldehyde emissions from two-stroke and four-stroke spark ignition engines with Methanol blended gasoline with catalytic converter, International Journal of Eng. Research and Tech.,3(3), 793.802.

Nedunchezhian N and Dhandapani S,(2000). Experimental investigation of cyclic variation of combustion parameters in a catalytically activated two-stroke SI engine combustion chamber, Eng Today, 2, 11-18.

Murali Krishna, M.V.S., Kishor, K., Murthy, P.V.K., Gupta, A.V.S.S.K.S. and Narasimha Kumar, S.,(2010). Performance evaluation of copper coated four stroke spark ignition engine with gasohol with catalytic converter, International Journal of Eng.Studies, 2(4), 465-473.

Narasimha Kumar, S., Murali Krishna, M.V.S., Murthy, P.V.K., Seshagiri Rao, V.V.R..and Reddy, D.N., (2011).Performance of copper coated two stroke spark ignition engine with gasohol with catalytic converter “International. Journal on Mechanical & Automobile Eng (IJMAE), 12(1), 36-43.

G. BAUMANN, Bosch Electronically Controlled Gasoline Injection System for Spark Ignited Engines, Robert Bosch G.m.b.H., Stuttgart, W. Germany (1967).

Effect of the injection pressure on the internal flow characteristics for diethyl and dimethyl ether and diesel fuel injectors, Thulasi vijaykumar , rajagopal thundil karuppa raj, and kasianantham nanthagopal.

K.Kumaravel, “Experimental studies on the Comparison of static fuel injection characteristics of fuel injectors used in GDI engine’’. International journal of advanced scientific and technical research’’ ISSN 2249-9954, 2014.

Aprilia S.P.A., “DITECH, Direct Injection Technology”, Press release, May 2000

Downloads

Published

30-09-2018

How to Cite

Himanshu Shukla, & Shubham Shukla. (2018). Study About Electronic Fuel injection systems, its advantages over Mechanical Fuel Injection System : A Review. International Journal for Research Publication and Seminar, 9(4), 37–41. Retrieved from https://jrps.shodhsagar.com/index.php/j/article/view/1346

Issue

Vol. 9 No. 4 (2018): Jul - Sep 2018

Section

Original Research Article

License

Copyright (c) 2018 International Journal for Research Publication and Seminar

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Re-users must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. This license allows for redistribution, commercial and non-commercial, as long as the original work is properly credited.