AN EXPERIMENTAL ANALYSIS OF SILICA FUME AND BLAST FURNACE SLAG WITH PARTIAL REPLACEMENT OF CEMENT AND SAND

Authors

  • Er. Rajan M.Tech Scholar, Department of Civil Engineering, JCDMCOE, Sirsa, India
  • Er. Sunil Kumar Assistant Professor, Department of Civil Engineering, JCDMCOE, Sirsa, India
  • Er.Vikram Assistant Professor and H.O.D, Department of Civil Engineering, JCDMCOE, Sirsa, India

Keywords:

Concrete cubes, tensile strength, blast furnace slag, construction material

Abstract

Growth in urbanization require large amount of construction material such as sand, cement, aggregates and due to high demand of these material their cost day by day increases. So it is very beneficial to replace these materials with some other material whose properties resemble with them. In this research we use silica fume and blast furnace slag with partial replacement of cement and sand. Concrete cubes and beams are prepared and their compressive strength, flexural strength and workability are tested and compared with the concrete have nominal mix. The concrete prepared is M25. The blast furnace slag used in the percentage of 0 percent, 10 percent, 20 percent, 30 percent & and silica fume in the percentage of 0 percent, 8 percent &16 percent separately. it is concluded that compressive strength and tensile strength is increases with increase in the percentage of blast furnace slag and silica fume and after that decreases.

References

Khajuria C&siddique R (2014) “Use of Iron Slag as partial replacement of sand to concrete”, International Journal of Science, Engineering&Technology Research (IJSETR), Vol. 3(6), Pp1877-1880.

Ramesh et al. (2013) “Use of furnace slag&welding slag as replacement for sand in concrete”. International Journal of Energy&Environmental Engineering 2013

K.GHiraskar&ChetanPatil (2013)“ utilization of blast furnace slag aggregate(course) in concrete”, International Journal of scientific&engineering research(IJSR), Vol.4(5),Pp 95-98.

Mohammed Nadeem, Arun D. Pofale (2012) “Experimental investigation of using slag as an alternative to normal aggregates (coarse&fine) in concrete” International journal of civil&structural engineering(IJCSE) Vol.3(1),Pp 117-127.

Ansu John&Elson John (2012)“Study onpartial replacement of fine aggregate using induction furnace slag”, American Journal of Engineering Research (AJER) Vol.4pp 01-05.

Dubey A, Dr .R. Chandak, Prof. R.K.Yadav (2012) “Effect of blast furnace slag powder on compressive strength of concrete”, International Journal of scientific&engineering research(IJSR), Vol.3(8) pp 01-05.

Downloads

Published

30-06-2018

How to Cite

Er. Rajan, Er. Sunil Kumar, & Er.Vikram. (2018). AN EXPERIMENTAL ANALYSIS OF SILICA FUME AND BLAST FURNACE SLAG WITH PARTIAL REPLACEMENT OF CEMENT AND SAND. International Journal for Research Publication and Seminar, 9(3), 20–24. Retrieved from https://jrps.shodhsagar.com/index.php/j/article/view/1331

Issue

Section

Original Research Article