A REVIEW ON HYDRAULIC PRESS DESIGN AND ITS OPTIMISATION
Keywords:
Finite Element Analysis, Optimization, Hydraulic press, deformation, continuous loadAbstract
Metal forming is a process which is done by deforming metal work pieces to the desired shape and size using pressing or hammering action. Hydraulic presses are being used for forming and pressing operations with wide range of capacities. Hydraulic press machine works under continuous impact load. Because of this continuous load, tensile and compressive stresses are experienced in various parts of machine. These stresses cause permanent deformation in some parts of machine. This work is based on optimization of a 250-ton four pillar type hydraulic press considering constraints like design, weight and cost. The work is focused on design and optimization of top plate of the press machine. Top plate holds the hydraulic cylinder and is one of the most critical parts of the machine. The design is based on sizing optimization method and the results are validated by Finite Element method with proper boundary conditions. The CAD modelling has been carried out by PTC CREO and for FEA, ANSYS software is used. Design Optimization of Hydraulic Press Plate using Finite Element analysis.
References
Akshay Vaishnav, Path Lathiya, Mohit Sarvaiya (2016) “Design Optimization of Hydraulic Press Plate using Finite Element Analysis” Int. Journal of Engineering Research and Applications ISSN: 2248-9622, Vol. 6, Issue 5
Gebremichael Tasew, Ajay Jaswal (2018) “Development of Single Hydraulic Cylinder Operated sheet metal Bending Machine” International Research Journal of Engineering and Technology (IRJET)
G. C. Mekalke, A.V. Sutar (2017) “Automation of a Hydraulic Press Machine Using Bosch Rexroth PLC for remote operation through mobile communication” International Journal of Advance Research, Ideas and Innovations in Technology. ISSN: 2454-132X Impact factor: 4.295
N. A. Anjum, M. Shah, S. Mehmood, W. Anwar, S. Anjum, M. S. Khalil (2017) “Design, Fabrication and Manufacturing of 100 Ton Hydraulic Press to Perform Equal Channel Angular Pressing (ECAP)” Technical Journal, University of Engineering and Technology (UET) Taxila, Pakistan Vol. 22 No. II-2017
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2018 International Journal for Research Publication and Seminar
This work is licensed under a Creative Commons Attribution 4.0 International License.
Re-users must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. This license allows for redistribution, commercial and non-commercial, as long as the original work is properly credited.