HEAT TRANSFER OPTIMIZATION OF FIN ARRAY CONSIDERING FIN THICKNESS AND LENGTH

Authors

  • Rinku Research Scholar, IIET Kinana Assistant Professor, IIET Kinana
  • Amit Mahal Research Scholar, IIET Kinana Assistant Professor, IIET Kinana

Keywords:

Heat transfer, Fin arrays, Heat transfer coefficient, Convective heat Transfer

Abstract

Heat transfer is a discipline of thermal engineering which is related to generation, use and conversion. It is also related to exchange of thermal energy among physical systems. The Fins are offering a trouble free & economical solution. It has provided solution in various situations. This type of situations demands natural convection of heat shifting. In the research work it has been concluded that if the heat transfer coefficient has been reduced then efficiency and effectiveness got increased but the Heat transfer got reduced. If length is increased then heat transfer and effectiveness got increased but the efficiency got reduced. If there is the increment in the temperature, the heat transfer got increased but the efficiency and effectiveness is not affected. The research work proposed the simulation of the Optimization of fin length to get particular effectiveness. It simulates the optimization of temperature to get particular heat transfer amount. As it could been seen the temperature should be Approximately 320 to get heat transfer of 390. The research work provides the Comparative analysis on the base of changes in heat coefficient, length and Temperature. This research is helpful in optimizing the configuration of Fin array during heat transfer.

References

M. I. Hasan, (2018)“Enhancing the cooling performance of micro pin fin heat sink by using the phase change materials with different configurations,” no. m, pp. 205–209, 2018.

N. Mansouri, C. Weasner, and A. Zaghlol, (2018)“Characterization of a Heat Sink with Embedded Heat Pipe with Variable Heat Dissipating Source Placement for Power Electronics Applications,” 2018 17th IEEE Intersoc. Conf. Therm. Thermomechanical Phenom. Electron. Syst., pp. 311–317, 2018.

K. K. Pathak, A. Giri, and P. Lingfa,(2017) “Thermal Performance of a Rectangular Vertical,” no. 2, 2017.

Davood AZIZIAN (2016) “Winding temperature prediction in split-winding traction transformer”,

Zhiwei Ma, Huashan Bao, Anthony Paul Roskilly (2016) “Performance analysis of ultralow grade waste heat upgrade using absorption heat transformer”, 2016 Published by Elsevier Ltd. under a Creative Commons

Gurpreet Singh, Swati Singh & Amit Singla wrote research in 2016 named “Experimental Studies on Heat shifting Performance of Double Pipe Heat Exchanger with using Baffles & Nanofluids”, Indian Journal of Science & Technology, Vol 9(40),2016

Mr. Lalit B. Chintamani, N.C. Ghuge (2015) “A Review Paper on Experimental Heat shifting improvement using Nanofluids”, International Journal of Innovative Research in highly developed Engineering Issue 2, Volume 2

Rajendra P. Patil, Dr. Atul Patil (2015) “Analysis of Steady State Heat Conduction in various Composite Wall”, International Journal of Innovative Research in Science, Engineering & Technology, Vol. 4, Issue 7, July 2015

Siddiqui. M. Abdullah, Dr. A. T. Autee (2015) “Experimental Analysis Of Heat shifting From Square Perforated Fins in Staggered Arrangement”, Siddiqui. M. Abdullah Int. Journal of Engineering Research & Applications , Vol. 5, Issue 8, (Part - 5) August 2015

Padam Singh andManoj Kumar (2014) “Free Convection in Heat shifting Flow on a Moving Sheet in Alumina Water Nanofluid”, Hindawi Publishing Corporation Journal of Engineering Volume 2014

Anurag S.Hatwar, V.M.Kriplani (2014) “A Review on Heat shifting improvement With Nanofluid”, International Journal of Advance Research In Science & Engineering, Vol. No.3, Issue No.3, March 2014

N. K. Chavda1, Jay R. Patel2 (2014) “Effect of Nanofluid On Heat shifting Characteristics Of Double Pipe Heat Exchanger”, International Journal of Research in Engineering & Technology, Volume: 03 Issue: 12

Rameshwar B. Hagote, Sachin K. Dahake (2014) “Study of Natural Convection Heat shifting on Horizontal, Inclined & Vertical Heated Plate By V-Fin Array”, International Journal of Scientific & Engineering Research, Volume 5, Issue 6,

S. Kumar (2014) “A Review: Enhancement of Heat Transfer with Nanofluids”, International Journal of Engineering Research & Technology, Vol. 3 Issue 4, April – 2014

Dr D P Mishra, S R Dixit, (2013) “Experimental Analysis of Heat Transfer And Average Heat Transfer Coefficient Through Fin Array With or With out Notch Using Free Convection

Downloads

Published

30-09-2019

How to Cite

Rinku, & Amit Mahal. (2019). HEAT TRANSFER OPTIMIZATION OF FIN ARRAY CONSIDERING FIN THICKNESS AND LENGTH. International Journal for Research Publication and Seminar, 10(3), 7–12. Retrieved from https://jrps.shodhsagar.com/index.php/j/article/view/1265

Issue

Vol. 10 No. 3 (2019): july-sept

Section

Original Research Article

License

Copyright (c) 2019 International Journal for Research Publication and Seminar

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Re-users must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. This license allows for redistribution, commercial and non-commercial, as long as the original work is properly credited.